The critical measurement is the gap beneath the edge of the table. A chair arm can sit several centimetres below the top surface and still strike the apron, the rail directly under the top. Check the lowest part the chair passes under, then check how far it can move inward before it reaches a leg or pedestal.
Measure two heights and one depth
Measure the floor-to-underside height at the front of the table where the chair enters. If the table has a decorative apron, support plate or thicker rim, take the lowest number along that path. Next, measure the highest point of the chair arm from the floor. On a sloping arm, that may be near the back. Measure the arm width too, then check the gap between table legs at the same height.
Suppose a table is 75 cm high and the apron comes down to 67 cm. An arm that peaks at 66 cm leaves only 1 cm on paper. A thick rug, felt pads or a slight change in the angle of approach can make a snug fit awkward. Try the pair in person if possible, especially if the chair needs to clear the table several times a day.

Work out how much tuck you actually need
Some arms clear the edge by a few centimetres before catching deeper under the top. If space is tight, measure the chair back with the chair as far in as it can go. Measure from that point to the wall or cabinet and check the path someone uses while walking past.
In a generous room, an armchair can sit slightly proud without causing much trouble. At an apartment table that borders the route to the kitchen, gaining a few centimetres when the chairs are put away can make breakfast and dinner easier to manage.
Try the change on just two seats
If you like the support of arms, try armchairs at the ends and armless chairs along the sides. Check the ends separately, because an apron or pedestal may extend farther there. Sit at the table before settling on the arrangement. The seat height, the thickness of the seat pad and the space for your thighs all matter once you have pulled the chair in. A piece of masking tape on the floor will help you keep track of which combinations worked.
From the collection

